This code is IMPORTANT, it’s used to generate a unique transponder ID. When I received my flight controller, it came in a small package that had a sticker with a QR code on the front of it. 3) Configure the transponder in Cleanflight If it’s on a wire, you can select which side of your craft is best, as each race the setup could be different. If you’re at a race and the transponders receivers are on one side, your LED might not have a good line of sight with those. I’d recommend not soldering it directly to the board, the reason is fairly simple. The second thing you need to consider when installing the transponder IR LED, is whether to solder it directly on to the FC board, or to solder some pins in then run wires from them. I suspect most buying this board will be using it for the racing transponder capability. If you select the RIGHT pointing arrow and middle square, it can be used to drive normal LEDs (such as WS2812). In this configuration, I’ve selected the IR Transponder by bridging the LEFT pointing arrow and the square in the middle. On the back of the EVO board, you need to bridge a solder joint which will let you select either to run IR LED as a racing transponder, or to drive normal Programmable RGB LEDs for aesthetics or visibility to other pilots. I have this listed as point two, because this is something you absolutely need to decide before you start tucking this away in to your frame. I am installing this FC on the TSX220 frame, which is quite tight for space, so I decided to use the straight header pins, as right angle pins will protrude too far out for my liking. I am going to swap out the old dead flight controller from one of my existing builds, to make way for the new one. 90 degree header pins and Straight header pins.3 UART’s (hardware serial port with built-in inversion).Built in Micro SD Card Recorder for saving Blackbox logs (Super long recording time and much faster data export).Built in transponder for racing (lap time recording)S.It’s designed for the familiar Cleanflight, and supports all the latest Cleanflight features. For the most part, this flight controller set-up is very similar to others I’ve used in the past. The SPRacing F3 EVO is an affordable flight controller yet full of awesome features.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |